B U L L E T I N : 2 1 0 0 0 6
Rear Suspension
Pivot Bushing
Failure
GM Crossovers
www.moogproblemsolver.com
and Minivans
PROBLEM: SOLUT ION:
Rear suspension
pivot bushing failure
GM crossover and minivan rear aluminum suspensions use
a “cross-axis” pivot bushing which is pressed into the upper
axle/hub carrier (or knuckle). This pivot bushing takes the
place of an upper ball joint. The OE part may experience
early failure, creating rear alignment change which can lead
to excessive tire wear. In addition, this part is not available
separately from the dealer. If the bushing is worn or failed,
the entire axle/hub carrier must be replaced.
MOOG®
K200175 Pivot Bushings
The MOOG K200174 and MOOG K200175 pivot
bushings correct the looseness and restore alignment
integrity. The lower pivot bushing K200175 is a companion
part suggested to be changed when the upper pivot bushing
is replaced. Since these parts are available separately, the OE
axle/hub carrier (knuckle) can be retained.
K200174 and
Pivot Bushing
MOOG K200174 upper pivot bushing
Description Years Make/Model Part Number
2002-2006 Buick Rendezvous
2005-2006 Buick Terraza
1994-1999 Cadillac Deville
1993-2002 Cadillac Eldorado
Rear
1993-1999 Cadillac Seville
Suspension
2005-2006 Chevrolet Uplander
Pivot
Bushings
2002-2005 Chevrolet Venture
2002-2004 Oldsmobile Silhouette
2001-2005 Pontiac Aztek
2002-2006 Pontiac Montana
1993 Cadillac Allante
K200174*
(Upper pivot
bushing)
and/or
K200175*
(Lower pivot
bushing)
Get The File |
Download here |
PDF Manual
